Setting Up And Using The Dvision Module - TILSBERK DVISION Manual De Instrucciones

4.2 Setting up and using the DVISION module

Charging
Fully charge your DVISION module before you use it for the first time. Use the USB-C charging cable
from the scope of delivery. As the power source, use a mains adapter with USB-A port or a suitable
electronic device, such as a computer or a charged power bank.
1. Connect the USB-C charging cable to a mains adapter with a minimum output of 0.5 A.
2. Connect the USB-C charging cable to the charging socket on the narrow end of the
DVISION module.
The DVISION module is being charged. The LED on the DVISION module lights up continuously.
Once charging is complete, the LED goes out. The full charge process takes approx. 4 hours,
if the battery of the DVISION module was completely flat at the start.
WARNING!
Do not leave the DVISION module unattended while charging. Only
charge the battery in a dry place and at temperatures ranging from 0 °C
to 45 °C (32 °F to 113 °F).
WARNING!
Charging the DVISION module in the helmet while riding can cause
accidents and lead to serious injuries. Pulling on the charging cable can
disconnect the DVISION module from the helmet adapter resulting in
the DVISION module falling into the helmet during the ride.
Never charge the DVISION module in the helmet during a ride.
NOTE!
Short charge cycles and complete discharges damage the battery and
shorten its lifespan.
To preserve the lifespan of your battery, avoid short charge cycles.
If possible, charge the DVISION module completely when the battery
charge level reaches approx. 20%.
If you store your DVISION for an extended period of time, re-charge
the battery approx. every 6 months.
O P E R AT I O N
EN
36