TILSBERK DVISION Manual De Instrucciones página 31

9. Carefully and evenly push the helmet adapter onto the mounting surface so that the entire
surface of the Sugru adheres to the helmet.
FIGURE 15 //
Example: straight and curved mounting surface
10. Check whether the helmet adapter sits correctly on the helmet. To do so, use the magnets to
attach the DVISION module to the helmet adapter.
The DVISION module must lie flush against the helmet adapter (FIGURE 15/1). There must be
no visible gap between the DVISION module and the helmet adapter (FIGURE 15/2a). Sugru can
compensate a curvature in the mounting surface (FIGURE 15/1a).
Checking the position of the helmet adapter
11. Fold down the sun visor to check that the sun visor does not collide with the helmet adapter or
the DVISION module.
12. Put your helmet on as usual.
13. Attach the DVISION module to the helmet adapter using the magnets and fold down the display
at a 45° angle.
The display should be well visible in front of your right eye.
14. Push the operating button on the DVISION module to switch on the device.
A screen appears on the display.
INFO
If the mounting surface is curved and the helmet adapter does not sit
correctly against the mounting surface, apply an additional layer of
Sugru to compensate for the unevenness.
I N - H E LM E T I N STA L L AT I O N
1a
1
2
2a
EN
30