Kenmore BC3005 Manual De Uso Y Cuidado página 23

Hose or hood electrical
connections.
Tripped overload protector in
Vacuum cleaner
PowerMate
starts but shuts
PROTECTOR (page 14).
off.
Tripped thermal protector in
canister.
PowerMate
unplugged.
Worn or broken belt.
®
PowerMate will Dirty brushroll or end caps.
not run when
attached.
Tripped overload protector in
PowerMate
PROTECTOR (page 14).
Handle switch set to FLOOR
position.
Full or clogged dust bag.
Dirty filters.
CHECK BAG
Indicator
Blocked airflow passage.
activates.
Certain attachment tools.
Vacuum cleaner
Wrong pile height setting.
picks up
moveable rugs
®
Suction too strong.
-or- PowerMate
pushes too hard.
Dirty power cord.
Cord won't
rewind.
Cord jammed.
Vacuum cleaner
leaves marks on Wrong vacuuming pattern.
carpet.
TROUBLESHOOTING
®
. See OVERLOAD
®
connections
®
. See OVERLOAD
- 23 -
Check connections, reconnect hose ends.
Remove any items that may be caught or
jammed, then restart. If vacuum cleaner starts
and stops again, clean brushroll and end caps,
then restart.
See THERMAL PROTECTOR (page 14).
Plug in firmly.
See BELT CHANGING AND BRUSHROLL
CLEANING. (page 19)
See BELT CHANGING AND BRUSHROLL
CLEANING. (page 19)
Remove any items that may be caught or
jammed, then restart. If vacuum cleaner starts
and stops again, clean brushroll and end caps,
then restart.
Slide handle switch to CARPET position to
®
activate PowerMate
Change bag.
Clean/change filters.
Clear blockage from airflow passage.
This is normal. Light should go off when tool is
removed.
Adjust setting.
Slide the electronic suction control to a lower
power setting.
Clean the power cord.
Pull out cord and rewind.
See VACUUMING TIPS. (page 11)
.