Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
Red Seal LED
Flashing
Vacuum Pump is
running, but bag is
not evacuating air
Bag is not sealing
properly
No lights on the
control panel
Nothing happens
when bag is
inserted
Tray Full LED
Flashing
Consumer Service: US: 1-877-777-8042 CA: 1-877-804-5383 MX: +52 55 5366 0800
Solution
•
Bag not inserted properly. Remove bag, wait for red light to stop
flashing and re-insert bag.
•
Always wait 20 seconds between seals.
•
Vacuum pump running more than 120 seconds. Under heavy usage,
appliance will shut off automatically and Red Light will flash. See next
section 'Vacuum Pump is running, but bag is not evacuating air'.
•
Unit overheated. Always allow 20 seconds between seals. Under heavy
usage, appliance will shut off automatically and Red Light will flash.
Wait for 20 minutes for unit to cool off.
•
If making a bag from a Roll, make sure one end of the bag is sealed.
(See "How to Make a FoodSaver
•
Adjust the bag and try again. Make sure the open end of the bag is
down inside the Drip Tray.
•
Check for wrinkles in bag along Sealing Strip. To prevent wrinkles in
the seal, gently stretch bag flat while inserting bag into Drip Tray.
•
Slide out drip tray drawer and make sure there are no foreign objects,
dirt or debris on the bottom gasket. (See "Care & Cleaning" on page
13.)
•
Too much liquid in bag; freeze before vacuuming.
•
Bag has wrinkles: To prevent wrinkles in the seal, gently stretch bag
flat while inserting bag into Vacuum Channel.
•
Unit overheated. Wait several minutes for unit to cool down.
•
Make sure unit is plugged in.
•
Make sure wall outlet is functional.
•
Press On/Off button.
•
Make sure unit has power (see above tip).
•
Tray Full; empty Drip Tray. Clean Drip Tray and place back into
appliance. (See "Care & Cleaning" page 13.)
•
Too much food in bag. Avoid overfilling. Allow 3 inches (7.62 cm) of
space between contents and top of bag.
•
Bag not inserted correctly. Insert bag curled down. Gently stretch bag
flat while inserting. Hold bag until Vacuum Pump starts.
•
Drip Tray has liquid or Drip Tray may be dirty. Empty liquid, clean Drip
Tray and place back into appliance. (See "Care & Cleaning" on page
13.)
®
Bag" on page 9.)
20
2022/3/3 上午9:12
2022/3/3 上午9:12
Tabla de contenido
Solución de problemas
