EN
Once the selected cooking time has
series of beeps for several seconds.
any sensor.The timer indicator (12)
the decimal dot (4) of the selected
alternately the H symbol and a "-".
If you wish to time another hotplate
If one or more zones are already
show by default the shortest remaining
related zone. Rest of timed zones will
show on their corresponding indicator
zones the decimal dot blinking. When
cursor "slider" of another timed zone
remaining time of that zone for a few
seconds and its indicator will show
its power level and the "t" alternately.
Changing the programmed time.
cursor "slider" (2) of timed zone has
to be pressed. Then it will be possible
to read and modify the time.
Through sensors
(10) and
you can modify the programmed time.
Disconnecting the clock
If you wish to stop the clock before the
done at any time by simply adjusting
its value to '--'.
1 Select the desired plate.
2 Adjust the value of the clock to "00"
by using the sensor
clock is cancelled. This can also be
done more quickly by pushing the
"sensors
(10) and
Fig. 7
46
same time.
Power Management function
(depending on model)
Some models are equipped with
a power limiting function (Power
Management). This function allows
the total power generated by the hob
after having connected the hob to the
the power limiting menu.
1 Press the
three seconds. The letter PL will
appear on the timer indicator (12)
2 Press the locking touch key
the hob can be limited will appear
and these can be changed using
the
(11) and
3
once again press the locking touch
key
(6). The hob will be limited
to the chosen power value.
you must unplug the hob and plug it in
again after a few seconds. Thus you
will again be able to enter the power
limiting menu.
Every time the power level of a
will calculate the total power the hob
is generating. If you have reached the
not allow you to increase the power
level of that hotplate. The hob will beep
and the power indicator (3) will blink
at the level that cannot be exceeded.
(10). The
must lower the power of the other
hotplates. Sometimes it will not be
enough to lower another by a single
(11) at the
level as this depends on the power of
each hotplate and the level it is set at.
It is possible that to raise the level of
a large hotplate that of several smaller
ones must be turned down.
If you use the quick switch-on at
maximum power function and the
said value is above the value set by
maximum possible level. The hob will
beep and the said power value will
blink twice on the indicator (3).
Special functions: CHEF
(depending on the model)
(11) touch key for
These functions have pre-allocated
obtaining excellent results as the
temperature of the pan is controlled
(6).
continuously by sensors. When the
target temperature for the function
maintained without needing to change
(10) sensors.
the power level.
The Chef functions operate correctly
with pans with the same ferromagnetic
area on the base of the pan as the
for high temperature functions (above
base (preferably "sandwich" type) as
Fig. 3
To ensure the correct operation of
pan and the cooking zone are not hot
at the start of the process.
Further information about suitable
etc.) is given on the Küppersbusch
web page.