EN
manufacturer in the
instructions for use
as adequate or
stovetop protectors
incorporated into
the device. The use
o f i n a d e q u a t e
p r o t e c t o r s c a n
cause accidents.
It is necessary
t o
a l l o w
a p p l i a n c e
disconnection after
i n s t a l l a t i o
n . Disconnection
devices must be
incorporated to
i n s t a l l a t i o n ,
according to the
installation regu-
lations.
Installation
Installation with cutlery drawer
Fig.2a (5 WIRES)
42
If you wish to install furniture or a
the two. Accidental contact with the
hot surface of the device's housing is
thus prevented.
ath the under part of the stovetop.
Electrical connection
Before you connect the stovetop to
t h e
together with this manual throughout
the product's service life.
Ensure that the inlet cable does not
come into contact with the induction
is installed in the same unit.
Warning:
The electrical connection
must be properly grounded,
following current legislation,
otherwise the induction hob may
malfunction.
Unusually high power surges
can damage the control system (like
with any electrical appliance).
It is advised to refrain from
using the induction hob during the
pyrolytic cleaning function in the
case of pyrolytic ovens, due to the
high temperature that this type of
device attains.
o f f i c i a l
t e c h n i -
cal service can handle or repair the
appliance, including replacement
of the power cable.
form the mains, we recommend
waiting for approximately 23
seconds before disconnecting from
the mains. This time is required to
allow for the complete discharge of
the electronic circuitry and thus
preclude the possibility of electric
shock from the cable terminals.
Keep the Guarantee
Certificate or the technical
data sheet together with the
instructions manual throughout
the product's service life. These
contain important technical
information.
About induction
Advantages
transmitted directly to the pan.
This has a number of advantages:
-Saves time.
-Saves energy.
-Easy to clean as if the food comes
does not burn easily.
-Improved energy control. The energy
is transferred to the pan as soon
as the power controls are pressed.
the power supply stops. It is not