Tabla de contenido
Important tips:
–
For a dust-free disposal of the vacuuming
material we recommend to insert the filter
bag as well. This provides the additional
advantage that the cartridge filter will not
become contaminated that quickly.
–
The filling level of the filter bag depends
on the dirt that is sucked in.
–
Change the filter bag regularlyso that it
does not burst!
–
The filter bag needs to be replaced more
frequently while sucking in fine dust, sand,
etc.
–
Use a preliminary separator while sucking
in ash or rust particles (order no. 2.863-
139).
Vacuuming hard surfaces
Illustration
Insert the hard surface inlay into the floor
nozzle. The bristles should point towards
the front.
Vacuuming carpeted floors
Illustration
Press both the locking flaps inwards.
Remove the hard-surface insert.
Wet vacuum cleaning
Do not use a filter bag!
Switch off the appliance immediately if
there is foam, liquid escape or if the
container is full!
Illustration
It is possible to suck in liquids using the at-
tachments shown in the illustration.
Note: If the container is full a float closes
the suction opening and the appliance
works at a higher speed. Switch off the ap-
pliance immediately and empty the con-
tainer.
Wet suction on hard surfaces
Use the hard-surface insert. The bristles
should point towards the front.
Wet suction on carpets
Work without the hard surface insert.
Working with connected electric
Illustration
Plug the enclosed adapter onto the suc-
tion hose and connect the electric tool
with the connection.
Illustration
Connect the mains plug of the electric
power tool to the vacuum cleaner.
A 2024 pt / A 2064 pt
Switch on the appliance (position I) and
switch on the electrical tool.
Note: Suction turbine and electrical tool
start running. The suction turbine contin-
ues to run even if the electrical tool is
switched off. Switch off the appliance, if
required.
A 2074 pt
Switch on the appliance (position II).
Note: The appliance is now ready for au-
tomatic operations. The suction turbine
has still not started
Switch on the electrical tool.
Note: The suction turbine starts with a de-
lay of 0.5 seconds. After the electric tool
has been switched off, the suction turbine
will continue to run for approx. 5 seconds
and the appliance is then switched off au-
tomatically.
Finish operation
After wet suction
Clean the dirty attachments.
Note: Suck in approx. 5 l of fresh water
through used attachment.
Illustration
Turn off the appliance and disconnect the
mains plug.
Empty the container, rinse with fresh wa-
ter and dry.
Illustration
Loosen the fixing of the cartridge filter.
Remove the cartridge filter.
tool
English 9
English
5
Tabla de contenido
