Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Inserting a Screw Strip
WARNING
source and/or battery pack from power
tool before making any adjustments,
changing accessories, or storing power
tools. Such preventative safety
measures reduce the risk of starting the
power tool accidentally.
1. After auto-feed attachment has been
mounted to tool, slide collated
screw strip (16) through the strip
guide on the auto-feed attachment
(Fig. 2).
2. To avoid jamming screws into auto-
feed attachment, carefully slide
collated screw strip through the
This tool is intended for driving and
removing screws. It is not suited for
high-torque applications such as driving
TEK® screws.
Variable Speed Controlled
Trigger Switch
Your tool is equipped with a variable
speed trigger switch (7). The tool can be
turned "ON" or "OFF" by squeezing or
releasing the trigger. The speed can be
adjusted from the minimum to
maximum nameplate RPM by the
pressure you apply to the trigger. Apply
more pressure to increase the speed
and release pressure to decrease speed
(Fig. 1).
"Lock-On" Button
The "Lock-ON" button (6), located on
the side of the handle, allows for
continuous operation at maximum RPM
without holding the variable speed
trigger switch (7).
TO LOCK TRIGGER "ON": squeeze
trigger (7), push in on "Lock-ON" button
(6), and release trigger (Fig. 8).
Assembly
Disconnect the plug
from
the
power
Operating Instructions
guide strip until first screw is
engaged
mechanism (Fig. 2).
3. An engaged screw strip must exit
through the top of the self-feeding
mechanism.
CAUTION
strip backwards. Any attempt to pull
screw strip through the bottom of the
self-feeding mechanism may damage the
auto-feed attachment. To remove screw
strip, pull strip from the top of the self-
feeding mechanism.
TO UNLOCK THE TRIGGER: squeeze
trigger (7) and release it without
depressing the "Lock-ON" button (6)
(Fig. 8).
Do not press the "Lock-ON" button (6)
to unlock the trigger (7). If the "Lock-
ON" button is continuously being
pressed, the trigger can not be released.
Also see "Rotational Direction Switch"
on page 12.
Fig. 8
7
-11-
in
the
self-feeding
After screw strip is
installed, do not pull
5
6
Tabla de contenido
