EBARA Ego 2 slim Manual De Instalación Y Operación página 34

ETHERNET
Only available in Module C, installed in variant Ego 2 slim and Module C.
The pump has a built in web server which allows you to access your pump directly via an existing Ethernet
connection. The default address for access to the pump is 192.168.0.245/
The web server uses HTML pages to set and view:
• Regulation mode settings
Regulation parameters (power, RPM, head, flow)
•
• Relay settings
External control inputs settings
•
• Current and previews error
• Pump statistics (power consumption, run time and other)
MODBUS
Only available in Module C, installed in variant Ego 2 slim and Module C.
Pump has built in Modbus client, through which we can access pump information using the RS 485 standard.
Modbus allows us to set and view:
Regulation mode settings,
•
• Regulation parameters (power, RPM, head, flow),
• Relay settings,
• External control inputs settings,
Current and previews error,
•
• Pump statistics (power consumption, run time and other).
RESETTING PUMP TO FACTORY SETTINGS
For resetting the pump to factory settings all three buttons must be held for 5 seconds. This way the pump will
set itself to automatic mode, delete previous height and power settings and unlock setting pump operation (if
locked).
Resetting of communications module needs following steps:
1. Disconnecting power from pump,
2. Set the 10-step switch to number 9
3. Turning the pump on and off again,
4. Setting the 10-step switch to number 1,
5. Turning the pump on.
Communications module should now be set to factory settings.
5 This also sets up the right twin pump.
5 (or 8 for left twin pump),
34