Installation; Safety; General Safety Instructions; Shower Operation - Stiebel Eltron PEY 18/21/24 Operación E Instalación

iNSTallaTiON

Safety

iNSTallaTiON
7. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
Material losses
!
Observe the maximum inlet temperature. Higher tem-
peratures may damage the appliance. You can limit the
maximum inlet temperature by installing a central ther-
mostatic valve.
WARNING Electrocution
This appliance contains capacitors which are discharged
when disconnected from the power supply. The capacitor
discharge voltage may briefly reach > 60 V DC.
7.2

Shower operation

CAUTION Burns
f If supplying a shower, set the internal temperature f
limit to "Tred"; see chapter "Installation alterna-
tives / Temperature limit".
CAUTION Burns
If the water supplied to the appliance is preheated,
please note the following:
The internally adjustable temperature limit may be ex-
ceeded.
f Limit the temperature with an upstream central f
thermostatic valve.
7.3

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
- The IP 25 (hoseproof) rating can only be ensured with a cor-
rectly fitted cable grommet.
- The specific electrical resistivity of the water must not fall
below that stated on the type plate. In a linked water net-
work, observe the lowest electrical water resistivity (see
chapter "Specification / Application areas / Conversion
table"). Your water supply utility will advise you of the specif-
ic electrical water resistivity or conductivity.
6 | PEY
All manuals and user guides at all-guides.com
8.
8.1
The following are delivered with the appliance:
- Wall mounting bracket
- Threaded stud for wall mounting
- Installation template
- 2 twin connectors (cold water with shut-off valve)
- Flat gaskets
- Cable grommet (power cable from above / below)
- Screws / rawl plugs for securing the back panel to allow for
For appliance replacement:
- 2 tap extensions
9.
9.1
f Always install the appliance vertically and near the draw-off f
The appliance is suitable for undersink and oversink installation.
Undersink installation
1 Cold water inlet
2 DHW outlet
Oversink installation
1 Cold water inlet
2 DHW outlet

Appliance description

Standard delivery

water connection on finished walls

Preparation

Installation location

Material losses
!
Install the appliance in a room free from the risk of frost.
point.
2
1
2
1
www.stiebel-eltron.com