Lock The Brake; Load The Wheel Tree - Cartrend 10441 Manual De Instrucciones

In order to use the wheel tree to store rims and rims with tires, additional assembly steps are
necessary.
1. Insert the lower tube (without plug) (3) into the locating hole on the frame (7) and fasten it with
a screw (ø 9 mm) (9) and nut (10 mm) (10).
2. Insert a locking pin (4) into the lowest pair of holes on the lower tube (without plug).
3. Attach a rest (2) to the lower tube (without plug).
Make sure that the lower flange of the rest clicks into the two grooves on the locking pin.
This prevents the locking pin from falling out of the pair of holes on the lower tube (without plug).
The wheel tree is now prepared for loading with rims / rims with tires.

Lock the brake

Locking the brake in the locked position is another necessary step in preparing the wheel tree for
loading. Proceed as follows:
1. Make sure the brake is working correctly (22).
2. Swing the brake lever inward toward the connecting tube (18). The brake ready for use when
the locking pin (4) on the brake clicks into a hole on the wheel (11).
3. To do this, move the wheel tree until the locking pin clicks into place in the wheel. When you
swing the brake lever outward toward the wheel, the locking pin on the brake disengages from
the wheel and you can move the wheel tree freely.
4. Lock the brake in the locked position before loading the wheel tree. Make sure that the locking
pin on the brake clicks into place in the wheel.
The wheel tree is now secured. You can begin loading the product.

Load the wheel tree

Warning!
Risk of accident and injury!
When loaded improperly, the wheel tree improperly may tip over, posing a risk of accident and
injury. Prevent the risk of the product tipping over by heeding the following instructions when
loading rims / rims with tires:
• Only load the wheel tree when it is standing on an even and stable surface.
• Make sure only to load the wheel tree when the brake is clicked into place in the locked position.
• Always begin loading from the lowest rest.
• Heed the maximum permissible load weight. (Max. load 100 kg, evenly distributed; max. 25 kg
per rest)
The wheel tree is now secured and ready for loading. Proceed as follows:
1. Lift the rim / rim with tire onto the lowest rest (2). Make sure that the outer side of the rim is up.
2. Guide the rim's center cap bore over the lower tube (without plug) (3) and place the rim on the
rest, with its contact surface facing downward.
3. Pick up the locking pin (4) and insert it into the nearest higher pair of holes. Heed the width of
the tires when selecting a pair of holes. There are two different rows of holes to choose from.
Operating Instructions
23