Assemble All Modules; Use Of The Wheel Tree; Prepare The Wheel Tree For Loading - Cartrend 10441 Manual De Instrucciones

Assemble all modules

A single screw connection is used to assemble all preassembled modules. Proceed as follows:
1. Pick up the preassembled frame (Fig. F).
Lay the frame (7) on a stable surface so that you can easily access the front wheel; the wheel
may not rest on the surface.
2. Insert the threaded pins on the frame through the holes on the rear axle with brake (8) and
through the holes on the connecting tube (18).
3. Place one washer (thick, 20 mm) (15) each on the threaded pins and tighten them with nuts (ø
9 mm / M8) (14).
Make sure the brake (22) is on the correct side (see Fig. F and G).
4. Place one spacer bushing (13) each between the connecting holes on both sides of the modules
(above and below, see Fig. G).
5. Insert one screw (ø 9 mm) (12) each through the spacer bushings and secure the modules with
washers and nuts.
6. Make sure that the wheel tree is secure and stable.
All components are now assembled and the wheel tree is fully assembled.

Use of the wheel tree

Prepare the wheel tree for loading

Before loading the wheel tree with rims or rims with tires, always check the product.
• Make sure that all parts of the wheel tree are assembled and fastened.
• In particular, make sure that the stopper (21) is correctly assembled. It prevents the wheel tree
from tipping over when loaded.
Mount the handle to aid in maneuvering the loaded wheel tree. Proceed as follows.
1. Pick up the handle (16) and attach it to the connecting tube (18) that sticks up from the
connecting tube module.
2. Screw the clamp screw (17) into the connecting tube (hand lever) and turn the screw connection
until the handle sits securely on the connecting tube (hand lever).
You can now maneuver the wheel tree. Use the handle to do so.
22
EN Mobile tyre holder