AEG SWD81800L1 Manual De Instrucciones página 11

Ocultar thumbs Ver también para SWD81800L1:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Problem
Audible or visual alarm is on. The cabinet has been re-
The lamp does not work.
The compressor operates
continually.
Water flows on the rear
plate of the refrigerator.
Water flows inside the wine
cellar.
DEMO appears on the dis-
play.
If the advice does not lead
to the desired result, call the
nearest brand-mark service.
Possible cause
cently switched on or the
temperature is still too
high.
The temperature in the ap-
pliance is too high.
The door is left open.
The temperature in the ap-
pliance is too high.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many products were put in
at the same time.
The room temperature is
too high.
Products placed in the ap-
pliance were too warm.
The door is not closed cor-
rectly.
During the automatic de-
frosting process, frost
melts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water col-
lector.
The appliance is in demon-
stration mode.
ENGLISH
Solution
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Close the door.
Contact a qualified electrician
or contact the nearest Author-
ized Service Centre.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Keep the Alarm pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
11
Tabla de contenido
loading

Este manual también es adecuado para:

Swd81800g1

Tabla de contenido