Assembly - RIDGID HDB6000 Manual Del Usuario

ASSEMBLY

INSTALLATION OF FILTERS (Fig. 3)
1. Unlatch the three clamps off of the top of the
Backpack Vac lid by pulling out from the bottom of
the clamps. Rotate clamp up and out of the three
lid's clamp lips.
2. Remove the lid and set it in a dry safe area.
3. Align and place the cloth filter (VFB102) (B) into the
Backpack Vac (A) so the rubber top edge is flush
with the Vac.
4. Align and position the dry filter bag (VFB600) (C)
into the cloth filter (B) located inside the Backpack
Vac (A) flush with the cloth filter's rubber top edge.
5. Align and replace the Backpack Vac lid onto the
Backpack Vac.
6. Rotate the three clamps up and onto the three lid's
clamp lips. Push in on the bottom of the three
clamps to secure the Backpack Vac lid.
Clamp (3)
Lid Clamp
Lip (3)
ROTATE
SP7128-1 HDB6000 ESF 2022.indb 7 SP7128-1 HDB6000 ESF 2022.indb 7
ATTACHING AND REMOVING VACUUM HOSE
(Fig. 4)
1. To insert hose into Vac inlet port: The Backpack
2. To remove the hose from the lid inlet Vac port:
Fig. 3
Lid Clamp Lip (3)
Backpack Vac Lid
Cardboard
Top Edge
Dry Filter Bag
(VFB600)
Rubber
Top Edge
Cloth Filter
(VFB102)
Backpack Vac
Clamp (3)
Cardboard
Top Edge
Rubber
Top Edge
7
Vac lid must be latched into place before inserting
the hose (D). Place the 90 degree end of the hose
into the lid inlet Vac port located on top of the
Backpack Vac lid. Push down on the hose until it is
completely inserted into the lid inlet Vac port and
snug against the hose lip.
Turn Vac OFF. Gently pull the hose (D) up and out
of the lid inlet Vac port.
Hose
Fig. 4
Hose 90 Degree End
Hose Lip
Lid Inlet Vac Port
Backpack
Vac Lid
8/11/22 11:27 AM 8/11/22 11:27 AM