Assembly - RIDGID HD03000 Manual Del Usuario

INTRODUCTION
UNPACKING
Check all parts from carton against the Carton Contents
List.
If any parts are damaged or missing, contact
1-800-4-RIDGID (US and Canada) or by email at
[email protected].
CARTON CONTENTS LIST (Fig. 1)
Key Description
A* Powerhead Assembly ........................................ 1
B* Dust Drum Assembly ........................................ 1
C* Qwik Lock™ Filter ............................................. 1
D Crevice Tool ..................................................... 1
E Dusting Brush . ................................................. 1
F Expandable Hose ............................................. 1
G Owner's Manual. ............................................... 1
* These parts come preassembled.
B*
C*
D
E
SP7125 HD03000 2022.indb 5 SP7125 HD03000 2022.indb 5

ASSEMBLY

ATTACHING AND REMOVING VACUUM HOSE
(Fig. 2)
1. To Insert Hose into Vac Inlet Port: Insert the
Expandable Hose (F) with the Locking Tab End
into the Vac Inlet Port, located on the side of the
Dust Drum (B), above the RIDGID SWEEP Label.
Push the Hose End straight into the Vac Inlet Port
until the Hose Locking Tab fully engages the Inlet
Qty
Port Ridges.
2. To Remove the Hose from the Vac Inlet Port:
Turn Vac OFF. Rotate the End of the Expandable
Hose (F) in either direction to release the Hose
Locking Tab from the Vac Inlet Port. Press the Hose
Locking Tab and pull the Hose End straight out of
the Vac Inlet Port.
Fig. 1
A*
(F)
F
G
5
Fig. 2
(B)
Inlet Port
Ridges
Vac Inlet
Port
Hose
Locking
Tab
SWEEP Label
6/2/22 10:21 AM 6/2/22 10:21 AM