Settings Table - Greenlee PDMM-10 Manual De Instrucciones

All manuals and user guides at all-guides.com
Operation
1. See the Settings Table. Set the measurement range selector to
the proper setting, starting with the highest measurement
setting. Never apply more than 300 V to the unit.
2. See Typical Measurements for specific measurement
instructions.
3. Test the unit on a known functioning circuit or component.
• If the unit does not function as expected on a known
functioning circuit, replace the battery and/or fuse.
• If the unit still does not function as expected, send the unit
to Greenlee for repair. See the address shown under
Warranty.
4. Take the reading from the circuit or component to be tested. If
the resolution is not satisfactory, remove the meter from the
circuit and change to the next lower range.

Settings Table

set the function
To measure
selector to this
this ...
symbol ...
AC Voltage
(300 V max)
DC Voltage
(300 V max)
DC Current
(250 V and
200 mA max)
Resistance
Diode/
Continuity
8
Electric shock hazard:
Contact with live circuits can result in
severe injury or death.
Connect in series and turn on circuit
or component.
Make sure circuit or component is
turned off and no voltage is present.
• Make sure circuit or component is
turned off and no voltage is present.
Polarity of red probe is +.
• Range selector must be in the
2k position.
• Tone indicates continuity.
Notes