Transport And Storage Of Cordless Tools - Hilti SFD 22-A Manual De Instrucciones Original

8

Transport and storage of cordless tools

Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
9.1 Troubleshooting
Trouble or fault
The power tool does not
work.
The power tool does not work
and one LED flashes.
The on/off button cannot be
pressed, i.e. the button is
locked.
LED 1 flashes
The battery runs down more
quickly than usual.
The battery does not engage
with an audible double click.
20 English
Possible cause
The battery is not fully inserted.
Battery is discharged.
Electrical fault.
Battery is discharged.
The battery is too hot or too cold.
The forward/reverse switch is in
the middle position.
Battery is discharged.
The tool is overloaded (application
limits exceeded).
Very low ambient temperature.
The retaining lugs on the battery
are dirty.
Action to be taken
▶ Push the battery in until it
engages with an audible double
click.
▶ Change the battery and charge
the empty battery.
▶ Remove the battery from the
tool and contact Hilti Service.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended operating temperature.
▶ Push the forward/reverse switch
to the left or right.
▶ Change the battery and charge
the empty battery.
▶ Pay attention to the power
and performance rating of the
product before using it, i.e
check its suitability for the job
on hand. See the "Technical
data" section.
▶ Allow the battery to warm up
slowly to room temperature.
▶ Clean the retaining lugs and
push the battery in until it
engages. Contact Hilti Service
if the problem persists.
2169940
*2169940*