Inserting The Battery; Removing The Battery - Hilti SFD 22-A Manual De Instrucciones Original

3. Use an approved charger to charge the battery. → page 16
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3

Removing the battery

1. Press the battery release buttons.
2. Remove the battery from the tool.
5.4 Fitting the belt hook (optional)
WARNING
Risk of injury. A falling power tool may present a risk of injury to yourself and others.
▶ Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by the operator. The belt hook can
be fitted to allow attachment on the left or right side of the body.
▶ Fit the belt hook.
5.5 Fitting the accessory tool
The power tool has a 1/4" hex socket with locking sleeve as a chuck for various accessory tools.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Push the locking sleeve on the hex socket forward.
▶ Hold the locking sleeve in this position.
3. Push the accessory tool into the chuck as far as it will go and release the locking sleeve.
4. Check that the accessory tool is held securely.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Selecting the gear
▶ Select the gear.
6.2 Setting forward or reverse rotation
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the middle position (switch-on
interlock).
▶ Set the forward/reverse switch to the desired direction of rotation.
18 English
2
3
4
5
2169940
*2169940*