LRP ANTIX S8REBEL BX3 Instrucciones página 17

SETTING THE FAILSAFE FUNCTION
This car is equipped with a fail-safe unit from the factory.
If there are reception problems due to radio interference or if the car goes out of range of the transmitter, the car should brake automatically.
The fail-safe unit is set from the factory. However, you should learn how to set it and check it before each trip.
The FAILSAFE output for channels 1 (steering) and 2 (throttle/brake) can be set as follows:
1. Switch on the transmitter and receiver to bring them into normal communication.
2. Set the throttle and steering of the transmitter to the position to be taken when the connection is broken and hold it.
3. Insert the supplied bind plug into the bind port on the receiver.
4. After the receiver LED flashes twice, remove the bind connector to save the FAILSAFE setting.
Check the setting by switching off your transmitter when the engine is not running.
GEFAHR
The servos in the vehicle must now assume the previously set position.
If this is not the case, repeat the steps above
WARNUNG
VORSICHT
HINWEIS
The failsafe unit cannot protect your car 100%.
RANGE TEST
To test the range of the radio system, give the car with the receiver switched on to a friend who can drive
it as far as you want. Check the correct function of the function of the RC system.
Do not drive if there are any problems during this test.
GEFAHR
WARNUNG
VORSICHT
HINWEIS
If you switch on the car first and then the transmitter, you may lose control of the vehicle.
REBIND TRANSMITTER & RECEIVER
Your transmitter comes already bound to the built-in receiver. If you have reception problems or the remote control
does not behave normally, try renewing the binding.
• Insert the BIND plug into the slot in the receiver shown above, and switch on the receiver. The receiver's LED
flashes rapidly to indicate that it is entering bind mode and waiting to bind. mode and is waiting to bind.
• Press the transmitter's BIND button and then switch on the transmitter.
The transmitter goes into bind mode. The LEDs1-5 light up alternately.
• After successful binding, the receiver LED lights up continuously.
The transmitter exits the binding mode after 5 seconds and the LEDs indicate the battery level.
CHECK THE RANGE
Especially when you are in a new place
for the first time.
Antenne
ENGLISH
BIND-Stecker
Kanal 4
Kanal 3
Kanal 2 / TH
Kanal 1 / ST
BIND / Batterie
LED
17