Install The Shading; Attach The Magnetic Hold-Down Brackets (Optional); Operation; Remote Operation - Levolor Sheer Shadings Manual De Instalación

INSTALLATION

Install the Shading

• Position the shading so that the
front (colored fabric) faces you.
• Slide the headrail into the
installation brackets so the edge
of the headrail is between the lever
and the bracket, as shown.
• Firmly push the headrail into each bracket until it clicks and the lever
snaps to the right side of the bracket.
IMPORTANT: Carefully pull on the headrail at each bracket to ensure it is
installed securely.

Attach the Magnetic Hold-Down Brackets (Optional)

• Lower the shading while keeping the vanes closed.
• Place the magnetic hold-down bracket onto the bottom rail just
inside the end cap, oriented as shown.
• Hold the bracket while opening and closing the vanes (it may
be necessary to have someone else assist you). Adjust the
bracket to the best overall position.
• Mark the screw location using the mounting options shown below.
— The screw should be placed in the middle of the channel. This will
allow for adjustment.
• Drill the screw holes using a 3 / " drill bit.
32
IMPORTANT: Use drywall anchors when mounting into drywall.
• Attach the hold-down brackets to the mounting surface
using the screws provided.
• If necessary, adjust bracket height by loosening the screw
and sliding the bracket up or down.
Outside Mount
Preferred Alternate
10
Sheer Shadings Motorized Operating System
Lever
Headrail
Installation
Bracket
Slide the Headrail
between the Lever
and the Bracket.
Bottom
Rail
Hold-Down
Bracket
Adjust the
bracket
using the
channel.
Inside Mount
Preferred Alternate

Remote Operation

• Scan for remote guide.

Battery Charging

• Rechargeable battery is integrated into
shade headrail.
• Use the standard micro-USB cable or
attach the magnetic charging adapter
to the 5V power adapter for simple and
easy charging.
• Indicator light battery status:
– Low (red flash)
– Charging (green flash)
– Charged (green solid)
• It is recommended to fully charge shade
prior to first use.
Troubleshooting
If your shading is not operating correctly:
• First review the guide that came with your product.
• Refer to the following troubleshooting procedures for specific solutions for your shade.
If questions remain, please contact LEVOLOR Customer Service at 1-800-LEVOLOR or
1-800-538-6567
Problem The shading will not fit into the installation brackets.
Check that the installation brackets are level and aligned.
Adjust and/or shim to level, if necessary.
Be sure the heads of the mounting screws are flush against the
installation bracket.
Solution
Make sure that the shading fabric is not caught between the
installation bracket and the headrail.
Check that the headrail is completely inserted into the installation
brackets. See "Install the Shading" on page 10.

OPERATION

Indicator Light
Programming
Button
Micro-USB Charging Port
Sheer Shadings Motorized Operating System
11