Introduction For Buttons On Remote Controller - HTW W2 Manual De Usuario E Instalacion

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Introduction for buttons on remote controller

Note:
● This is a general use remote controller, it could be used for the air conditioners
with multifunction; For some function, which the model doesn't have, if press the
corresponding button on the remote controller that the unit will keep the original
running status.
● When power is connected (stand by condition), you can operate the air
conditioner through the remote controller.
● When unit is on, each time you press the button on remote controller, the sending
signal icon "
ditioner gives out a beep sound, it means the signal has been sent.
● When unit is off, set temperature will be displayed on the remote controller (If the
light of the unit display is turned on, the corresponding icon will be displayed);
When unit is on, it will display the icon of the on-going function.
1
HEALTH button
Press this button to trun on/OFF health function .
Note:This function is not available for this model.
2
SWING button
Press this button to turn on left & right air swing.
3
ON/OFF button
Press this button to turn unit on/off.
4
MODE button
Pressing this button once can select your required mode circularly as below (the
corresponding icon "
● When selecting auto mode, air conditioner will operate automatically according to
ambient temperature. Set temperature can't be adjusted and won't be displayed
either. Press SPEED button to adjust fan speed.
● When selecting cool mode, air conditioner will operate under cool mode. Then press
+ or - button to adjust set temperature. Press SPEED button to adjust fan speed.
● When selecting dry mode, air conditioner will operate under dry mode. Then press
+ or - button to adjust set temperature. Press SPEED button to adjust fan speed.
● When selecting fan mode, air conditioner will operate in fan mode only. Then press
SPEED button to adjust fan speed.
● When selecting heat mode, air conditioner will operate under heat mode. Then
press + or - button to adjust set temperature. Press SPEED button to adjust fan speed.
(Cooling only unit can't receive heating mode signal.)
"on the display of remote controller will blink once. If the air con-
" will be lit up after the mode is selected):
AUTO
COOL
DRY
FAN
HEAT
42
Tabla de contenido
loading

Este manual también es adecuado para:

Wbc-035-w2

Tabla de contenido