Eco Energy-Saving Setup; Operation - Tripp-Lite SMART600PSGLCD Manual Del Propietário

7. ECO Energy-Saving Setup

The ECO energy-saving feature enables your UPS system to save energy by automatically turning off designated outlets when
your computer is turned off or in Standby Mode. ECO Mode is disabled by default.
Enabling ECO Mode
1. Connect essential peripheral devices to the "Controlled by Master Outlet" outlets on the "Battery & Surge Only" side for
battery and surge protection, with the option of being controlled by the Master Outlet.
2. Connect a master device, such as a desktop computer or audio/visual receiver to the master outlet.
Note: A minimum of 20W is required for the master outlet to power on.
3. With the UPS system turned on and operating normally from utility power, press and hold the Up/Down button for 2
seconds to enter the LCD menu. Navigate to P13 to enable or disable ECO Mode.
4. When the UPS system detects a drop in load (<20W) on the master outlet for approximately 3 minutes, it will turn off
the "Controlled by Master Outlet" outlets. The 3-minute delay ensures the ECO outlets remain powered during a reboot.

8. Operation

LCD Panel and Front Panel Buttons
During normal AC and Battery mode operation, the UPS front-panel LCD screen will not be illuminated. To turn on the LCD
backlight, press and release the front panel POWER button (release within 0.5 seconds or less to turn on the LCD backlight
only).
Note: When turning on the UPS backlight only, be careful to press and release the POWER button quickly. Pressing and holding the power
switch for 2 seconds will immediately power off the UPS.
10