Setup Screen; General - Tripp-Lite SmartOnline SV Serie Manual Del Propietário

9. Control Panel
Battery
Positive Voltage (V)
Negative Voltage (V)
Positive Current (A)
Negative Current (A)
Battery
Remain Time (Min)
Charging Status

9.3.6 Setup Screen

Use "Down/Right" key to select "Setup" option. A password is required to access the menu sub-screen. Default password is 0000.
HOME

9.3.6.1 General

The SETUP – GENERAL screen may be accessed in any UPS operating mode. Some settings may only be amended in certain modes; refer to
table 9.3 for details. The Maintenance password (9999) is required for settings marked with *.
GENERAL
Battery positive voltage, Units 0.1V
Battery negative voltage, Units 0.1V
Battery positive current, Units 0.1A
Battery negative current, Units 0.1A
Battery runtime remaining, Units 1 minute
Percentage of battery capacity remaining, Units 1%
Capacity (%)
Battery test result
Test Result
Battery charging status (settable per section 9.3.4 Control Screen)
MENU
Set current time / system install date / system latest maintenance date / battery install
Time*
date / battery latest maintenance date
Set new password
Change Password
Set "Disable" or "Enable" (default: Enabled)
Audible Alarm
Restore to factory default settings
Factory Reset*
Set EEPROM default
EEPROM Reset*
Set EPO "Normal Close Active" or "Normal Open Active"; Default: Normal Open Active
EPO Function*
Save EEPROM setting
Save Setting*
Enter Password
SETUP
24
GENERAL
SYSTEM
BATTERY
PRE-ALARM