Ridgid Contact Information; Description - RIDGID RP 115 Manual Del Operador

tions may damage the press tool, damage
the attachments and/or cause personal
injury.
• Use proper tool, attachment and fitting
combinations. Improper combinations
can result in an incomplete joint, which
increase the risk of leaks, equipment dam-
age and injury.
• Do not modify tool. Modifying the tool in
any manner may result in personal injury
and voidance of the tool's warranty.
• Before operating a RIDGID
read and understand:
– This operator's manual
– The battery/charger manual
– The fitting manufacturer's installation
instructions
– The instructions for any other equip-
ment or material used with this tool
Failure to follow all instructions and warn-
ings may result in property damage and/
or serious injury.
RIDGID Contact
Information
If you have any question concerning this
RIDGID product:
®
– Contact your local RIDGID distributor.
– Visit RIDGID.com to find your local
RIDGID contact point.
– Contact Ridge Tool Technical Service
De part ment at rtctechservices@emer son.
com, or in the U.S. and Canada call (800)
519-3456.

Description

The RIDGID RP 115 Press Tool is designed
®
to be used with RIDGID Mini Series Attach-
ments. Mini Series Jaws are available to
mechanically press PureFlow
ViegaPEX™ and FostaPEX™ tubing and
ProPress fittings for copper and SS tubing.
An individual jaw set is required for each size
and type of tubing. Jaw sets and press tool
must be used perpendicular to the fitting/tube
being pressed.
When the run switch on the press tool is de-
pressed, an internal electric motor powers
a hydraulic pump which sends fluid into the
cylinder of the tool, moving the ram forward
and applying force to the attachment, pressing
999-995-408.10_REV. A
the fitting. The press cycle takes approximately
3 seconds.
A work light turns ON when the trigger/run
switch is depressed to illuminate the work
area. The head can be rotated 270° for better
access in tight spaces.
The tools are supplied with fabric loops that
can be used with appropriate attachments
such as shoulder straps or tie off lines.
ViegaPEX™ and FostaPEX™ are trademarks of Viega
PureFlow
of Viega
Press Tool,
®
Viegener II GmbH & Company.
Jaw Set
Attachment
Mounting
Figure 1 – RIDGID RP 115 Press Tool with Jaw
Size
Marking
Figure 2 – RIDGID Mini Series Jaw Set
Fittings for
®
RP 115 Press Tool
® and ProPress ® are registered trademarks
. Viega ® is a registered trademark of Franz
®
Pressure
Release Button
Handle
Tool
Trigger/
Status
Run
Light
Switch
Pin
® .
Fabric Loop
Warning
Label
Battery
Work
Serial
Light
Number
Plate
System Marking
Return
Spring
5