Instruction For Installation; Installation Warnings - Tecnogas FN3K66E4SX/1 Manual De Uso

INSTRUSTIONS FOR INSTALLATION
Installation must be carried out by an authorized technician according to the guidelines. Our
company cannot be held responsible for the damages to people, animals or properties due to
improper installation.

INSTALLATION WARNINGS

Dimensions and materials of the cabin or cupboard in which the built-in oven will be installed in
have to be correct and it has to be resistant to temperature increases. Please install as shown in
Figure.
*The furniture walls in which the oven is installed in must be heat resistant. Wall panels must be
resistant to 100 C especially if the side walls are made of wallboard. Plastic or adhesive panels that
are not resistant to this heat may deform and sustain damage.
*For safety reasons, direct contact with electrical parts of the oven must be avoided.
*Isolation and protective parts must be installed in a way to prevent them from being removable
by any tool.
*Oven must be installed as in Figure in order to provide a more effective air flow.
*It is advised to leave a space of at least 40 mm on the back for the kitchen unit in which the oven
is installed.
*A support must be placed under the oven which can carry the weight when placing the oven.
*The back section of the cabin in the kitchen unit must be removed in order to provide better air
flow.
*It is not advised to install the device near refrigerators or freezers, otherwise performance of said
devices would be affected from the heat radiated.
*Place the device centered on the inlaid cabin.
*Open the oven lid and mount the body to the countertop with four woodscrews by aligning the
holes on the sides.
*Oven can be mounted to a cupboard up top or under the counter if desired.
*When mounting an electrical built-in stove on the counter over the oven, electricity cables of the
oven and the stove must be separated in order to dismount the oven from the stove when
necessary.
SEE THE FIGURE
5