Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Use the following procedure to change the saw
blade:
1.
Pull out the power plug of the machine.
2.
Turn the disconnected machine onto the motor
unit. The saw blade points upward.
3.
Insert the Allen key (B) into the flange screw
(12) and turn it counterclockwise until the
saw shaft locks into place.
➢
The saw blade is retained in position and
the flange screw can be released.
4.
Using the Allen key (B), turn the flange screw
(12) counterclockwise to loosen it.
5.
Remove the flange screw (12) and the front
clamping flange (13).
6.
Remove the old saw blade.
Clamping flanges must be free of
➢
adhering parts!
➢
The new saw blade can now be installed.
7.
Position the new saw blade (14) on the rear
flange (16).
Ensure that the direction of rotation is
➢
correct when you install the saw blade.
The saw teeth or the arrow on the saw
blade (14) must point in the direction of
the arrow (15) on the machine.
8.
Fit clamping flange (13) and flange screw (12).
9.
Using the Allen key (B), turn the flange screw
(12) clockwise to tighten it.
The saw blade is secured.
➢
16
Fig. 9: Removing the old saw blade
Fig. 10: Replacing the saw blade
K85Ec / KSS80Ec 370
01/2022
Tabla de contenido
