Controls + Features - SNOWJOE 24V-X4-SB24-CT Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Assembling the Handles
1. Slightly spread the upper handle assembly down over the
lower handle until it fit in the position (Fig. 6).
Fig. 6
Upper handle
assembly
Handle knob + bolt
2. Adjust upper handle assembly to the optimal position
by aligning the double bolt holes at the desired height.
Secure the connection using the 4 handle knobs and
bolts, and tighten on each side (Fig. 7).
Fig. 7
2
1
2-position handle
height adjustment
Discharge Chute Assembly
1. Place the discharge chute assembly onto the gear plate,
and push down until the chute is flush and flat against the
housing (Fig. 8).
Fig. 8
Discharge
chute assembly
Gear plate
2. With the holes on the discharge chute pole aligned with
the holes on the housing, use the 12 mm open end
wrench to secure the 2 chute bolts with the discharge
chute assembly (Fig. 9).
Fig. 9
Discharge
chute pole
12 mm wrench end
Lower
3. Clip the cord clip onto the lower handle frame, insert the
handle
discharge chute cable into the cord clip (Fig. 10).
Fig. 10
Cord clip
Discharge
chute cable

Controls + Features

m
WARNING!
entire safety section before proceeding.
Snow blower controls and features are described below and
illustrated in Fig. 11.
Control Panel (Fig. 11)
Fig. 11
Auger speed
control lever
9
Chute bolts
AVOID INJURY. Read and understand the
LED switch
Reverse indicator LED
Reverse
Drive speed
button
control lever
Chute
control lever
Tabla de contenido
loading

Tabla de contenido