SNOWJOE 24V-X4-SB24-CT Manual Del Operador página 10

1. Auger speed control lever – The auger rotation speed
can be increased from 116 rpm to 143 rpm by pushing the
auger speed control lever forward.
2. LED switch – Press
on the front panel for nighttime snow removal.
3. Reverse button – Press
snow blower in reverse mode. The reverse indicator LED
will light up to indicate the reverse mode is activated.
4. Drive speed control lever – Use the drive speed control
lever to control the marching speed of the machine. When
machine is marching, push the lever forward to increase
the speed, pull it back to reduce the speed.
5. Chute control lever – The chute control lever can be
used to adjust the chute direction up to 180 degree, as
well as to lower/raise the chute deflector.
Adjust the discharge chute direction by pulling backwards
or pushing forwards the chute control lever until the chute
has rotated into the desired position (Fig. 12).
To adjust the chute deflector, keep pressing the discharge
chute lock button and at the same time push down or
raise up the chute control lever (Fig. 13).
2
Push down or Pull up
Press in the lock button
1
Chute deflector
NOTE: ALWAYS position discharge chute deflector at a safe
angle before engaging the auger.
DO NOT throw snow any higher than necessary.
m
WARNING!
NEVER direct the snow discharge chute at
the operator, at bystanders, at vehicles, or at nearby windows.
The discharged snow and foreign objects accidentally picked
up and thrown by the snow blower can cause serious damage
and personal injury.
Always orient the discharge chute in the opposite direction
from where the operator, bystanders, surrounding vehicles, or
windows are located.
to utilize the LED lights located
reverse button to enter the
Fig. 13
Auger Trigger (Left-Handle) (Fig. 14)
Fig. 14
1. Flip up the safety switch, then squeeze the auger trigger
against the left‑handle to engage the auger and start snow
throwing action.
2. Release auger trigger to stop.
Drive Trigger (Right-Handle) (Fig. 15)
Squeeze the drive trigger against the right‑handle to engage
the wheel drive for propelling unit. Forward speed will vary
according to snow depth and moisture content.
Drive trigger
Fig. 15
(Right-handle)
NOTE: When travelling to or from the area to be cleared, press
down on the handle grips enough to raise the front of the
unit slightly off the surface. Engage the drive trigger without
engaging the auger trigger.
Chute Clean-Out Tool
The chute clean‑out tool is fastened to the top of the auger
housing with a mounting clip (Fig. 16).
Fig. 16
Chute clean-out tool
Mounting clip
10
Auger will
start rotating
Auger trigger
(Left-handle)
Safety
switch
Wheels will
drive