Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Starting the Machine
IMPORTANT! Make sure both triggers are released before
inserting the battery packs.
1. Open the battery compartment cover and slide four
battery packs down until they all click and lock into
position (Fig. 18). Close the cover.
Fig. 18
2. Flip up the safety switch, then squeeze the auger trigger
against the left‑handle (Fig. 19). The auger will start
rotating and plowing snow.
Fig. 19
NOTE: Auger trigger should be engaged before drive trigger
when throwing snow.
3. Use the auger speed control lever to set a comfortable
plowing speed (Fig. 20).
Battery
compartment
cover
Battery packs
Flip up the safety
1
switch
2
Squeeze the
auger trigger
Fig. 20
Auger speed
control lever
IMPORTANT! DO NOT overload unit capacity by attempting to
clear snow at too fast a rate. Use slow speed to clear deep or
hard packed snow.
4. Squeeze drive trigger against the right‑handle and the
snow blower will move (Fig. 21). When the blower is
moving steadily, you can release the drive trigger while
keeping the auger trigger squeezed to maintain the snow
blower's movement. Release the auger trigger and both
the drive motion and plow motion will stop.
Fig. 21
Drive trigger
(Right-handle)
5. Use the drive speed control lever, adjust the speed for a
comfortable pace (Fig. 22).
Fig. 22
IMPORTANT! Drive speed can be changed without stopping
the snow blower.
12
Drive speed
control lever
Tabla de contenido
