SPORTSTECH F37s Guia Del Usuario página 29

4.2 PREPARING THE CONSOLE CLAMPS
4 x
B
4 x D
Hex
2 x E
Turn the console assembly ('K') upside down (as shown
•
in the figure) and put it on a safe support with soft surface.
Put the brackets ('E') into the console. Do not mix up the brackets: They are colour-marked. Bring each
•
bracket to the position with the corresponding colour mark in the console.
Fasten each bracket with two screws ('B') and spring washers ('D'). Screw in the screw connections
•
with a 6 mm Allen key (Hex).
4.3 FASTENING AND CONNECTING THE CONSOLE
Hex
Mul
If possible, have a second person help you with this step.
Turn the console ('K') into the normal orientation. Connect the cable ('CC') from the console to the
•
cable from the main frame ('CM').
• Place the mounted brackets of the console in the two support bars. Do not pinch the cable.
Fix the console on each support bar with one long screw connection at each bracket (long screw ('A'),
•
washer ('J'), nut ('G')). Use the Allen key ('Hex') and the multifunctional key ('Mul').
• Then, fix the console on each support bar with a short screw connection at each bracket (short screw
('B'), washer ('J') and spring washer (' D')). Use the Allen key ('Hex').
Insert the two bottle holders ('Bo') into the recesses of the console.
•
Check the firmness of
•
the screw connections.
The device is now
ready for use.
B
D
E
4 x
A
B
4 x
Cu
B
D
J
A
A
G
J
B
D
E
K
8 x D 2 x
J
8 x
Cu
B
D J
G
J
R
B
A
F
Bo
CC
CM
R
G
DE
EN
29