before you begIn
NOTE: Always remove the battery pack of the immersion
blender before cleaning the metal blade.
Before using the cordless rechargeable immersion blender,
Waring suggests that you wipe the unit with a clean, damp cloth
to remove any dirt or dust. Place the metal blade end of the hand
blender under running water to rinse it. Dry thoroughly with a
soft absorbent cloth. Read all instructions completely for detailed
operating procedures.
Intended uSe
The Waring
Cordless Rechargeable Immersion Blender is
®
intended for use in restaurants, small kitchens and small
companies when mixing and liquefying. You can operate directly
in the pot to mix everything from soups, stews, creams and
salad dressings to pancake mixes, pastes, sauces, mayonnaise
and much, much more. For nurseries or for special diets use the
Cordless Rechargeable Immersion Blender to prepare purées of
vegetables, porridge, fruit creams, etc.
operatIon
Important: Use the WSB25E/K immersion blender only with
battery pack WSB25BPE/K, wall-mount charger WSB25WME/K,
or rapid desk charger WSB25CSE/K. The use of any of these
parts with any other units or accessories not recommended by
Waring is prohibited and may result in injury.
1. It is suggested to mount the wall-mount charging station near
an accessible outlet. To mount the wall-mount charger, use
the metal bracket included with the unit. Screw the metal
bracket into a sturdy part of the wall or into a stud using two
screws. The two tabs that hold the wall mount charger should
point upward. Slide these two tabs into the mounting holes
on the back of the charger, with the cord at the bottom. The
charger will function on a tabletop, although wall-mounting is
recommended.
2. Plug wall mount charger into outlet. The red light on the front
panel will illuminate to indicate that the charger is ready for
charging.
3. Mount the battery pack on the top of the immersion blender
by sliding the bottom of the battery into the hole until you
hear a click.
6