Install The Side Discharge Chute; Set The Cutting Height; Install The Battery Pack; Remove The Battery Pack - GreenWorks Powerall LME476 Manual Del Operador

EN
7.4 INSTALL THE SIDE DISCHARGE
CHUTE
14
When you use the side discharge chute,
• Do not install the grass catcher.
• Keep the mulch plug installed.
1. Open the side discharge door (13) and hold it.
2. Line up the recesses of the side discharge chute (4) below
the pivot (14).
3. Close the side discharge door.
7.5

SET THE CUTTING HEIGHT

The machine can be set to different cutting heights.
1. Pull the height adjustment lever rearward to increase the
cutting height.
2. Pull the height adjustment lever forward to decrease the
cutting height.
English (Original Instructions)
13
CAUTION
7.6

INSTALL THE BATTERY PACK

15
4
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
Both batteries should be installed into the compartments in
order to start the machine.
1. Open the battery door (6).
2. Align the grooves on the battery pack (15) with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Do the same operation with the other battery.
6. Close the battery door.
The motor starts only when you put in the safety key (16).
7.7

REMOVE THE BATTERY PACK

1. Open the battery door (6).
2. Remove the safety key (16).
3. Push and hold the battery release button (17).
4. Remove the battery pack from the machine.
8

OPERATION

Wear eye protection during operation.
10
6
17
WARNING
NOTE
ATTENTION
WARNING
16