Unfold The Lower Handle; Install The Grass Catcher; Install The Mulch Plug; Install The Side Discharge Chute - GreenWorks LMC420 Manual Del Operario

3.3

UNFOLD THE LOWER HANDLE

Figure 3
1. Pull up on the handle holes to release the lower handles.
2. Fold the lower handle up until the handle pins lock into
position.
Make sure that the two handle pins are in the same position.
3.4

INSTALL THE GRASS CATCHER

Figure 4
1. Remove the mulch plug.
2. Remove the side discharge chute.
3. Open the rear discharge flap and hold it.
4. Hold the the grass catcher by its handle and engage the
hooks on the door rod.
5. Close the rear discharge flap.
3.5

INSTALL THE MULCH PLUG

Figure 5
1. Remove the grass catcher.
2. Open the rear discharge flap and hold it.
3. Hold the mulch plug by its handle and fit it in the
discharge chute.
4. Close the rear discharge flap.
3.6 INSTALL THE SIDE DISCHARGE
CHUTE
Figure 6
CAUTION
When you use the side discharge chute,
• Do not install the grass catcher.
• Keep the mulch plug installed.
1. Open the side discharge flap and hold it.
2. Line up the recesses of the side discharge chute below the
pivot.
3. Close the side discharge flap.
3.7 SET THE BLADE/CUTTING
HEIGHT
The machine can be set to different blade/cutting heights.
Figure 7
1. Pull the height adjustment lever rearward to increase the
blade/cutting height.
2. Push the height adjustment lever forward to decrease the
blade/cutting height.
NOTE
English
3.8

INSTALL THE BATTERY PACK

Figure 8.
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
The machine has an automatic switch function that lets the
other battery work when the first cannot operate.
1. Open the battery compartment flap.
2. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery compartment.
The engine starts only when you put in the safety key.
3.9

REMOVE THE BATTERY PACK

Figure 8
1. Remove the safety key.
2. Open the battery compartment flap.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.
4

OPERATION

Wear eye protection during operation.
4.1

START THE MACHINE

Figure 9
1. Make sure safety key is inserted into slot.
2. Push and hold the start button.
3. While you hold the start button, grab the start handles in
the direction of the handle bar.
4. Once the machine has started, you can release the start
button.
5. Press the Turbo button to speed up to 3,200RPM.
5
WARNING
NOTE
NOTE
WARNING
EN