Maintenance - Tineco FLOOR ONE S5 COMBO Serie Manual De Uso

MAINTENANCE

Note:
• For optimal performance and to prevent odors,
always clean and dry DWT, floater, filters, brush
roller, brush roller cover completely after each
use.
• Please make sure each part is installed correctly
or the appliance may not work properly.
• After maintenance, place the appliance on
the charging base vertically. Do not expose
the appliance to direct sunlight, and store it
indoors in a dry place.
Main Body
1.To reduce the risk of injury, switch off before
performing maintenance.
Fig.D-1
2.Use a cloth to clean the surface with a neutral
detergent. The cloth should be dry to prevent
water from entering the appliance.
Fig.D-2
3.When the indicator of Dust Sensor Malfunction
blinking, remove Dirty Water Tank, clean the
dirt sensor with a damp cloth or the cleaning
tool.
Fig.D-3
Dirty Water Tank
1.When dirty water reaches the Max line,
the appliance will stop working and show
a reminder on the display and play a voice
prompt.
2.Pull up the tank lid to empty the DWT. Use
the cleaning tool to remove remaining debris.
Rinse the inside of the DWT and place back
into the appliance.
Fig.D-4
Dirty Water Tank Lid
• If the Dirty Water Tank lid and the filter inside
have been blocked, remove the tank lid and
the filter, rinse both parts with water.
Fig.D-5
Dry Filter
Grasp recessed area on each side of the dry filter
and pull upward. Rinse under running water and
must be completely dry before recombining with
the lid of the DWT.
* A spare dry filter is provided with your
appliance for convenient replacement.
Fig.D-6
Brush Roller Self-cleaning
1.Place the appliance on the charging base after
use, the sensor will auto-detect the level of dirt.
2.When you hear the voice prompt "please
begin self-cleaning cycle," press the self-
cleaning button and begin the process.
3.Once complete, you will hear the voice prompt
"self-cleaning completed, please clean the
Dirty Water Tank." At this point, the appliance
will begin charging.
Fig.D-7
Note:
• Ensure the charging base is plugged in and the
battery level is >15%.
• Before self-cleaning cycle, please clean the
DWT and ensure the water level in the CWT
exceeds 40%.
Brush Roller Cover
1.Squeeze latches on the cover and pull upward
to remove.
Fig.D-8
2.Rinse with water.
Fig.D-9
3.When replacing, always latch the brush cover
into place to avoid leakage.
Fig.D-10
Brush Roller
1.Remove the brush roller by grabbing the brush
roller tab and pulling out.
Fig.D-11
2.Using the cleaning tool, remove the hair and
debris wrapped around the roller and rinse with
water. Replace the brush roller back into the
accessory holder, and allow it to dry completely
before reinstalling.
Fig.D-12
28