Replacing The Fuse; Installing The Battery - Steren MUL-035 Manual De Instrucciones

3.- Do the measure.
4.- Read the value of the resistance in the green Ohm scale.
If you cannot set the arrow to zero, you must change the If you cannot set the arrow to zero, you must change the
battery. battery.
MEASURING DECIBELS (dB)
1.- Connect the testing point to the right jacks.
2.- Set the dial to the 10v range and read the dB scale.
To obtain an accurate measure of dB, the impedance of the To obtain an accurate measure of dB, the impedance of the
circuit must be 600 Ω circuit must be 600 Ω

REPLACING THE FUSE

Caution:
To avoid electrical shocks, unplug the testing points before to
change the fuse. Only use a 0,5A/250V fuse, in order to avoid
damages to the circuit.
1.- Use a screwdriver to remove the screws from the back cover.
2.- Replace the fuse with a new one (0,5A, 250V).
3.- Do not touch any other area out of the fuse case.

INSTALLING THE BATTERY

For measuring resistance it is necessary to use a battery.
To install it, use a screwdriver to remove the cover.
Then place a AA battery into the compartment, pay attention to
polarity.
Never leave old batteries inside of the multimeter. Remove them
if you won't use the multimeter for a long period of time.
TESTING A BATTERY
1.- Connect the testing point to the right jacks.
2.- Set the dial to the BATT 1,5V range.
3.- Read the value in the screen.
The characteristics for this multimeter are subject to change The characteristics for this multimeter are subject to change
without notice. without notice.
ENGLISH-4