Placing Battery; How To Use; How To Connect The Test Cables - Steren MUL-650 Manual De Instrucciones

PLACING BATTERY

Remove the screws and the battery
compartment cover
screwdriver, and insert a "9 V" battery.
Be sure to place the battery polarity
correctly.
If the symbol appears on the screen,
it means that you must replace the
battery.

HOW TO USE

CAUTIONS DURING USING
• To avoid the electric shock risk, do not connect the test tips if the Multimeter cover is not in place.
• The selection knob must be in the correct position for the test.
• To avoid electric shock and damage in the Multimeter, do not exceed the maximum values shown in the specifications.
• Never change the knob position of the at random during the measurement.
• To avoid electrical shock or damage in the Multimeter, do not attempt to take any voltage measurements exceeding 60
VDC and 30 VAC.
• The protective fuse must be only replaced by one of the same type and specification.

HOW TO CONNECT THE TEST CABLES

Insert the black cable connector into the COM terminal.
Insert the red cable connector on the 20 A, μA mA or V Ω Hz terminals.
Red cable
using a
SELECT HOLD RANGE
Hz
Hz
(IL 25mA)
V
OFF
20A
MAX 10 SEC.
A
CAT.IV 600V
mA CAT.III 1000V
COM
T
20A MAX FUSED
400 mA MAX FUSED
UP
REL
A
mA
A
V Hz
Black cable
T
UP
6