Field Of Application; Specific Safety Instructions - SOMFY ilmo2 50 S WT Guia De Instalacion

TRANSLATED INSTRUCTIONS
These instructions apply to all ilmo2 50 S drive, the different versions of which are available in
the current catalogue.

Field of application

ilmo2 50 S drive are designed to drive all types of roller shutters equipped with stop blocks and
rigid links.
The installer, who must be a motorisation and home automation professional, must ensure that
the motorised product is installed in accordance with the standards in force in the country in
which it is installed such as EN 13659 relating to roller shutters.
Liability
Please read these instructions carefully before installing and using the drive. In addition to follow-
ing the instructions given in this guide, the instructions detailed in the attached Safety instruc-
tions document must also be observed.
The drive must be installed by a motorisation and home automation professional, according to
instructions from Somfy and the regulations applicable in the country in which it is commissioned.
It is prohibited to use the drive outside the field of application described above. Such use, and
any failure to comply with the instructions given in this guide and in the attached Safety instruc-
tions document, absolves Somfy of any liability and invalidates the warranty.
The installer must inform its customers of the operating and maintenance conditions for the drive
and must provide them with the instructions for use and maintenance, and the attached Safety
instructions document, after installing the drive. Any After-Sales Service operation on the drive
must be performed by a motorisation and home automation professional.
If in doubt when installing the drive, or to obtain additional information, contact a Somfy adviser
or go to the website www.somfy.com.

Specific safety instructions

Cables which pass through a metal wall must be protected and isolated using a sheath or
sleeve.
Attach cables to prevent any contact with moving parts.
If the drive is used outdoors, and if the power supply cable is a type H05-VVF cable, the
cable should be installed in a UV-resistant duct, e.g. under a gland.
Leave the drive power supply cable accessible: it must be possible to replace it easily.
Always make a loop in the power supply cable to prevent water entering the drive.
For tubular motors 50/60 mm in diameter:
The drive wheel must be locked in place to prevent it moving along the roller tube:
- Either by securing the roller tube onto the drive wheel using 4 screws or 4 pop rivets
positioned between 5 mm and 15 mm from the outer edge of the drive wheel, suitable for
all types of roller tube. The screws or pop rivets must only be attached to the drive wheel
and not to the drive.
- Or by using a drive wheel stop, suitable for tubes which are not smooth.
Somfy Activités SA, F-74300 CLUSES as manufacturer hereby declares that the drive
covered by these instructions when marked for input voltage 230V~50Hz and used as
intended according to these instructions, is in compliance with the essential requirements
of the applicable European Directives and in particular of the Machinery Directive
2006/42/EC and EMC Directive 2014/30/EU.
The full text of the EU declaration of conformity is available at www.somfy.com/ce.
Christian REY, Approval manager, acting on behalf of Activity director, Cluses, 04/2016.
38 Copyright © 2008 - 2017 Somfy Activités Société Anonyme. All rights reserved.