Connecting The Water To The Appliance; Aligning The Ice-Water Dispenser - Thermador T18 Serie Instrucciones De Instalación

Connecting the water to the appliance

Note:
When bending the water line, do not kink it, otherwise
there is a risk of leaks and water damage
1. Remove the cap from the appliance connection (
2. Bend the water line accord ing to the location of the
connection on the appliance (
3. Push the union nut and seal onto the water line.
4. Push the end of the wate
connection and screw on the union nut (
Tighten hand-tight.
5. Using the open-ended wrench, tighten the union nu
Do not overturn!
6. Push back the water line
as possible ( 4.).
7. Open the shut-off valve and main water tap.
8. Check the connection on the shut-off valve and on
the appliance for leaks.
9. Close the shut-off valve.
All manuals and user guides at all-guides.com
.
1.).
2.).
r line into the appliance
3.).
t.
into the guard tube as far

Aligning the ice-water dispenser

(for freezer unit with ice-water dispenser only)
Note:
In the case of appliances with a high-grade steel do
there is a special covering frame.
The ice-water dispenser can be aligned inside the c
of the door panel. This allows the dispenser to be
parallel to the door panel in order to obtain an op
overall appearance.
Note:
We suggest to attach the
dispenser unit!
1. Slide cover frame onto the ice-water dispenser an
press in until the frame is flush with the door surface.
2. Loosen screws on the 4 clamps (
3. Insert flat screwdriver into one of the 4 slots an
push the blocks sideways until the ice-water
dispenser has the same distance from the door
panel ( 2.).
4. Retighten the screws on the clamps (
utout
aligned
timum
frame before adjusting the
1.).
3.).
or,
d
d
31