Aligning The Appliance In The Installation Enclosure; Attaching The Appliance To The Installation Enclosure - Thermador T18 Serie Instrucciones De Instalación

1. Aligning the appliance in the
installation enclosure
Note:

To ensure that the appliance functions correctly,
it must be set perfectly levelled.

Do not twist or jam th e appliance inside the
installation enclosure! When adjusting the height-
adjustable feet, proceed gradually: Always alternat
between left and right, etc.

For easier adjustment of the rear feet take the wei
off by slightly tilting the appliance forward.

Do not bend the appliance against the anti-tip-
brackets.
The positioning aid on the door have been designed
the following total thic kness of door panels:

3 /
4 " (19 mm)

1 1 / 2 " (38 mm)
Always take account of the
of the panel fronts which are
1. Align the appliance with th e cabinet fronts using the
positioning aid.
Place level over the positioning aid on the door.
The height-adjustable feet at the front and rear ca
adjusted from the front.
with open-ended wrench 1 / 2 "
Front:
(Width across flats 13 mm)
with 5 / 16 " (8 mm) hex nut driver via flexible
Rear:
shaft.
The mark (a) attached at the appliance base is used
a standard gage for height
the height, align this mark at a height of 1
above the floor.
It is very important to comply with this dimension for the
subsequent alignment of the furniture fronts.
16
All manuals and user guides at all-guides.com
ght
possible differing thickness
to be fitted subsequently.
n all be
adjustment. When adjusting
1 /
2 " (32 mm)
The height adjustment gauge (b) is used
to set this height correctly. The upper
edge of the gauge must be in alignment
with the mark on the appliance.
2. Unscrew the feet at the front of the appliance un
the mark (a) on the applianc e is in alignment with the
upper edge of the height adjustment gauge (b).
e
for
3. Align the appliance vertically using the feet
at the back. Use a level!
2. Attaching the appliance to the
installation enclosure
It is essential to attach th e appliance to the top of the
installation enclosure.
1. Screw the attachment pl ate lugs (top) to the
overhead furniture.
2. If there is a fairly large gap above the appliance
fit a wooden beam above the appliance, ensuring
that the wooden beam fits the gap exactly.
as
til
,