Environmental Protection Information - Orima ORCD 350 2P Manual De Instrucciones

 Water has appeared under the appliance. The thaw water collection tray has
slipped off the compressor. Place the tray on top of the compressor.
 When the appliance door is opened, the rubber sealing gasket pulls out. The
gasket is smeared with sticky foodstuffs (fat, syrup). Clean the sealing gasket and
the groove for it with warm water containing soap or dishwashing detergent and wipe
dry. Put the rubber sealing gasket back into the place.
 High temperature in appliance, the compressor operation pauses are short.
Ascertain whether the appliance door/doors are shutting tightly, whether the door
wasn't kept open longer than necessary when taking out or putting in foodstuffs or
whether a large amount of warm food was placed in the appliance.

The top of the appliance has condensation on it. The ambient relative air
humidity is above 60 %.
possible remove the cause of the humidity.
THE MANUFACTURER WILL NOT BE RESPONSIBLE FOR ANY DAMAGE OF THE
APPLIANCE
INSTRUCTIONS FOR TRANSPORTATION.

The appliance should be transported only in the vertical position.

When being transported, the appliance should be protected from atmospheric
conditions (rain, snow, dampness).

The appliance should be firmly secured in place while being transported, to avoid
slippage or any shocks in the transport vehicle.

If the appliance was transported not vertically, it may be connected to the
mains after 4 hours at least. If this is not done, the appliance compressor
may fail.

ENVIRONMENTAL PROTECTION INFORMATION

This symbol indicates that once the appliance is no longer needed, it cannot be
disposed together with other miscellaneous municipal waste. It should be
collected and eliminated separately, i.e. in containers specially marked with this
symbol in large-dimension rubbish collection areas. Full information on where to submit
the old appliance safety can be obtained from local government authorities, the shop
where you bought the appliance or the manufacturer's representatives.
If you decided to scrap the appliance, make it impossible to use in order to prevent
possible misadventure. Pull out the electric plug from the electricity supply socket and
then cut off the cord. Tear off the gasket. Break the door lock if any.
WARNING! Do not dismantle the appliance yourself. Pass it on to recycling
companies.
Ventilate the room where the appliance stands and if
TRANSPORT
THAT RESULTS FROM NON-COMPLIANCE
28
WITH THE