Preparing The Appliance For Operation - Orima ORCD 350 2P Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

PREPARING THE APPLIANCE FOR OPERATION

It is recommended to prepare the appliance for operation with a helper.
Remove package. Lift the appliance away from foamed polystyrene base.
Do not rise or push it taking by handles. Handles may break.
Therefore take out adhesive tapes from sides and simply lift the appliance up and
take out the board. Strip adhesive tapes off and open the
door. Remove the spacer above the door.
When positioning the appliance in chosen location, it will
move more easily into position if you lift the front a little
and incline it backward allowing it to roll on its casters.
Suitably dispose the packaging material.
Take two supports from the bag (see fig.) and insert them
into the guides at the top back part of the appliance.
If the appliance is brought in from the cold (temperature is not higher than +12 °C),
you should wait for two hours before connecting it to the mains.
The appliance should not be connected to the mains until all packing and transport
materials aren't removed
Place the appliance in a dry, well ventilated room.
WARNING! The appliance should not be operated in an unheated room
or porch. Place the appliance away from heat sources such as kitchen
stove/oven, radiators, or direct sunlight.
WARNING! The appliance must not touch any pipes for heating, gas or
water supply or any other electrical devices.
Do not cover the ventilation holes at the top of the appliances –
it must be a good air circulation around the appliance. There
should be a gap of at least 10 cm between the top of the
appliance body and any furniture that may be above it. If this
requirement is not followed, the appliance consumes more
electrical energy and its compressor may overheat.
If the appliance is placed in a corner, a gap of at least 1 cm
must be left between the appliance body and the wall (see fig.).
The appliance must stand on a level surface and must not touch
the wall. If necessary, regulate the height of the appliance by
adjusting the levelling feet: by turning them clockwise – the
front of the appliance rises, by turning them counter clockwise –
it comes down. If the appliance is tilted slightly backward – the
doors will close by themselves
.
POSITIONING
.
24
Tabla de contenido
loading

Tabla de contenido