BRENNTAG HEATSAVR Manual De Instalación página 8

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

5.0
ALARM
Alarm Displayed
Level
Flow
Parameter Error
Clock Fail
To restore the initial parameters (Default), perform the following steps:
Unplug the system from the power supply.
Keep pressed UP and DOWN keys.
Plug the system to the power supply while UP and DOWN are kept pressed.
The system will display
Press the UP or DOWN keys to avoid resetting the default parameters
Press Enter to confirm
Default Parameters:
Language: English
Time: Maintain the set time
Unit: ml
Relay: alarm
Flow: off
Password: 0 (Disabled)
6
MAINTENANCE AND ACCESSORIES
6.1
Replacing the squeeze tube
Make sure that the right-hand switch is on the " O " position and proceed as follows:
 Remove the screws and cover protecting the peristaltic pump.
 Place the thumbscrew holder with the two thumbscrews in a vertical position.
 Remove the connector situated to the left of the pump from its seat and pull the tube fitting towards the
front panel. While the tube is being withdrawn, follow its path by turning the roller in a clockwise
direction by hand until the connector to the right of the pump can also be removed.
 To re-assemble, move the roller assembly so the two rollers are horizontal to each other.
 Push the connector to the left of the pump in as far as it will go, with the curved part towards the bottom;
 Press the tube fitting into its seat, following its path progressively by turning the roller assembly in a
clockwise direction by hand, until the tube fitting situated to the right of the pump can also been seated
properly.
 Replace the protecting cover into place and resecure with the screws. It
will now OK to position the right-hand switch on " I ".
H E A TS A V R
Description
Chemical Low level alarm
Waiting for external signal
Parameter Errors
Clock error
Init. Default
YES
Init. Default
NO
C od e 0000137248
Solutions
- Restore product
- Restore Flow
-Press Enter to restore the
initial parameters
-Press Enter to restore
operation
rev . 1 . 0
7
Tabla de contenido
loading

Tabla de contenido