Getting Started - BRENNTAG HEATSAVR Manual De Instalación

1

GETTING STARTED

1.1 Welcome
Heatsavr systems is high quality product suitable for many applications requiring timed dosing.
The simplicity of the programming process makes this system easy to use.
�
Please review this manual carefully. Pay particular attention to warnings and precautions.
Always follow good safety procedures, including the use of proper clothing, eye and face protection.
�
Please be sure to read this manual and select operating mode before installation.
1.2 What's in the box?
Before you start, check that your box contains the
following items:
A. Heatsavr
B. PVC 4x6 mm (¼" OD) tube 5m (16 ft)
C. Anchor plugs + screws
D. Ceramic weight + suction filter
E. FPM non-return valve (3/8" GAS)
F. PE 4x6 mm (¼" OD) tube 5m (16 ft)
G. Fixing bracket
1.3 Technical features

Power supply available: 100-240 VAC

Consumption: 8 W

Flow rate: 12 l/h (6.8 oz)

Max back pressure: 1,5 bar (22 PSI)

Protection of the System: the sealed enclosure on the Heatsavr is highly water resistant and the
electronics are further protected within the enclosure.

Dimensions: H 234 x W 162 x L 108 mm (H 9,2" x W 6,4" x D 4,3")

Weight:1 Kg (2.2 lbs).
1.4 Warnings
�
Read this manual carefully before installation and before starting up the Heatsavr.
�
When using the installation and programming settings indicated in this manual.
�
For all connections refer to the topographical diagram for the control circuit given in this
manual.
�
WARNING: Always follow the necessary safety procedures, including the use of adequate
protection for the eyes, face, hands, and clothing.
�
WARNING: When installing or carrying out maintenance on this equipment, always disconnect
it from the power supply.
�
We are constantly striving to improve all its products, and we therefore reserve the right to
make changes at any time without notice.
�
Failure to abide by the indications given in this manual may result in injury to people or
property damage, or compromise or damage the equipment itself.
Material required during installation
1.5
�
An installation kit is available (see Maintenance & Accessories).
H E A TS A V R
HEATSAVR
INSTRUCTION
C od e 0000137248
MANUAL
F
rev . 1 . 0
Enter
Prog
Esc
S et
G
1