3.2
Calibration Function
MO DE
Completely install the system with a
graduated container at the inlet.
Press the Enter key to start the motor at
100%. The display will show the dosing
count in seconds:
Calibration
??? sec
It's recommended to let the system run
at least 30 seconds for a precise
calibration.
Note: max time for calibration is 6
minutes.
�
The calibration function allows more precise dosing.
�
The system is already calibrated for 12 l/h (6,8 oz/min) with water and no back pressure. For precise dosing to
a specific application calibration is necessary.
H E A TS A V R
M O DE
Prime the system
1
Press the Enter key again to stop the
dosing and the display will show:
Quantity?
??? ml
Press the UP and DOWN keys to enter
the actual dosed value. Press the Enter
key to confirm and set the pump
calibration.
4
C od e 0000137248
Keep the Set key pressed for at least 3
seconds to access to the Settings menu,
press Down or Up until the Calibration
window is reached.
2
??? oz
5
Calibration
ENTER to START
MO DE
The system is calibrated. Position
the foot filter in the chemical tank.
rev . 1 . 0
3
6
5