Clock Setup - BRENNTAG HEATSAVR Manual De Instalación

3.1 SETTINGS
Set the system (the right-hand switch must be ON).
The Settings menu can be accessed by pressing the Set key for at least 3 seconds.
If a password other than 0 is set, the system will ask for the password to access the programming menu.
Upon release of the key the display will show:
Language
English

Clock Setup

Mon
Unit
ml
Relay
Alarm Function
Flow
Off
Calibration
ENTER to START
Change Password
0
H E A TS A V R
Display
10.26am
C od e 0000137248
Description
You can set the language of the system (EN, DE, ES;
FR, IT). Start to set by pressing the Enter key and
select the language with UP and DOWN. To confirm
press Enter.
With this window you can set the date and time.
Start to set by pressing the Enter key and select the
values using with UP and DOWN. To confirm press
Enter.
You can set the measure unit of the system: ml or
oz. Start to set by pressing the Enter key and select
the values using with UP and DOWN. To confirm
press Enter.
You can set the relay mode as such:

Alarm Func.: the relay switch-on with the
alarm.

Pump After: the relay and the motor are
activated simultaneously, but deactivation of
the relay is delayed (adjustable time 0-999
sec.).

Pump Before: the relay is activated before
the motor (adjustable time 0-999sec.) and is
deactivated simultaneously.

Off: relay disabled.
*If time of Pump After or Pump Before is "0" the
relay will work simultaneously to the pump.
You can activate (on) or deactivate (off) the Flow
function. Start to set by pressing the Enter key and
select the values using with UP and DOWN. To
confirm press Enter.
In this window you can allows more precise dosing,
by doing the calibration. (see the paragraph 3.1 Calibration Function)
The password can be modified by choosing an
incremental value between 0 and 9999. Start to set
by pressing the Enter key and select the values
using with UP and DOWN. To confirm press Enter.
rev . 1 . 0 4