4 Operating
GB
4.2
Skin test
40
All manuals and user guides at all-guides.com
The skin test serves to check tolerance and for a better estimation as to
how your skin will react to the treatment. Perform this at least 48 hours
before the first application on the area of skin to be treated. Proceed as
follows:
1.
Plug the end of the device plug of the power supply cable
device and the power supply plug
cator
illuminates red.
3
2.
Press the ON/OFF button
up at Level 1, the readiness indicator
time and the device fan switches itself on. The device is now ready for
positioning on the skin.
3.
Place the light area
trigger a light pulse at intensity level 1. The skin contact area
lie fully on the skin (if case of adequate skin contact the readiness in-
dicator
starts to flash green), so that a light pulse can be emitted by
3
the device. When the pulse is emitted, you will see a bright flash and
may hear a clicking sound.
4.
Now place the device on another area of the skin while it charges for
the next light pulse.
5.
Then emit a new light pulse on the other skin area.
6.
Repeat this procedure for further areas of skin, for which a treatment
is planned.
7.
End the skin tolerance test (switch off the device by pressing and hold-
ing the ON/OFF button
skin areas that have been treated. If they appear normal (no reactions
or only slight redness), the areas of skin tested can be treated. How-
ever if the areas of skin display strong, painful or other unusual reac-
tions, you may not carry out any treatment on the corresponding skin
areas. In this case contact your doctor.
into a socket. The readiness indi-
4
. The intensity display
1
3
onto the skin and press the trigger button
6
) and wait at least 48 hours. Check the
1
5
begins to light
2
lights up green after a short
into the
to
8
must
7