Before You Begin - Kohler K-528-K1 Instrucciones De Instalación

Before You Begin

1-9/16"
(40 mm)
2-11/16"
(68 mm)
2-3/8"
1-7/16"
(60 mm)
(37 mm)
CAUTION: Risk of product damage. Do not apply excessive heat near the valve. This valve contains plastic and
rubber components that will melt if heat is directly applied.
NOTICE: Do not install the valve in any location where the temperature may exceed 104°F (40°C). The valve and its
integrated power supply are rated to operate in temperatures up to 104°F (40°C).
NOTICE: Do not apply petroleum-based lubricants to the valve components. Doing so will damage the valve
components.
IMPORTANT! Read these instructions and determine the locations for all required components before beginning
installation.
This valve is not intended for single-outlet use unless pairing two outlets for a high flow bath filler.
For optimum performance, dedicated water supply lines are recommended.
If possible, install the valve before installing the digital interface(s).
If possible, flush all piping thoroughly before installing the valve. If the pipes are flushed after the valve is installed, clean
the inlet filters before using the system.
A qualified electrician should install a 120 V GFCI electrical outlet, within the stud framing, above the valve.
If possible, install the electrical outlet before installing the valve.
Kohler Co.
9-7/16" (240 mm)
12-1/2" (318 mm)
2"
1-13/16"
(51 mm)
(46 mm)
12-1/2"
(318 mm)
9-1/2"
(241 mm)
3-3/8"
(86 mm)
1"
(25 mm)
5
1-5/16"
8-1/16" (205 mm)
(33 mm)
13/16"
(21 mm)
10-3/16" (259 mm)
11-5/8" (295 mm)
13-3/8" (340 mm)
1145587-2-E