Replacement Of The Feeler Pin - Butler AIKIDO.34LIGHT Manual De Instrucciones

• At regular intervals, at least every two months, verify
the rubber protections conditions, in relation to point 3.0 Safety devices. If necessary replace damaged parts
requesting for them to the supplier.
• Every week and/or when necessary, top up the oil tank
using the filler hole provided closed by a cap or screw
on the lubricator filter.
N.B: This operation should not be carried out by
unscrewing the cup of the lubricator filter.
• The use of synthetic oil might damage the pressure
regulator filter.
• At regular intervals, (at least every 100 working hours)
check reduction gear (Fig. 49 pos. 1) lubricating oil
level. Such operation must be effectuated removing the
plug (Fig. 49 pos. 3), positioned on the provided hole
prearranged on the frame, and removing the plug po-
sitioned on reduction gear (Fig. 49 pos. 2).
Fig. 49
THE MANUFACTURER DOES NOT
ACCEPT ANY DAMAGE RESULT-
ING FROM THE FRAILURE TO
OBSERVE THE ABOVE INSTRUC-
TION, AND SUCH FAILURE
COULD INVALIDATE THE WAR-
RANTY!!
All manuals and user guides at all-guides.com
INSTRUCTION, USE AND
MAINTENANCE MANUAL
AIKIDO.34LIGHT-AIKIDO.34LIGHTFI

13.1 Replacement of the feeler pin

After a certain number of operations it's possible that
the (upper and/or lower) feeler pin can deform so that it
can't ensure a proper functioning; in this case its re-
placement can be carried out following these simple op-
erations (Fig. 50):
• Unscrew the deformed feeler pin
• Replace it by a new feeler pin, keeping the head of the
screw pressed in order to facilitate this operation.
THE FEELER PINS MUST BE
ABSOLUTELY ORIGINAL; DON'T
REPLACE THEM WITH IMPRO-
VISED FEELER PINS, DON'T
MODIFY THE ORIGINAL FEELER
PINS.
Fig. 50
7101-M001-0_B
Page 42 of 111
GB