Parameter Settings - STAMOS S-LS-96 Manual De Instrucciones

3.3.2.

Parameter settings

1. Setting the voltage or current value
Press the "V/A" button (17) to select the output parameter to be
edited.
Use the (15) and (16) buttons to set the cursor position to the
position in the voltage/current value record to be changed (this
sets the parameter adjustment accuracy between coarse and fine).
2. Locking the settings
Press the "Lock" button (11) to lock the parameter editing.
The button will light up, the other buttons and the dial will be
locked.
To unlock the editing, press the "Lock" button (11) again, the
backlight will turn off and the functions of the other buttons will
be restored.
3. Audible signal
An audible alarm is given when overload or overvoltage protection
is activated.
The audible alarm is factory set to on. To turn the alarm off/on
again, press the knob (18).
4. Saving / recalling settings
To save new settings press one of the M1-M4 buttons (7-10), the
button will light up and the display will show the current voltage
and current values.
At this point, enter the preferred voltage and current parameters
following step 1 of the current subsection.
When the parameters on the display stop flashing, they are saved
under the previously selected button.
Press one of the M1-M4 buttons (7-10) to recall the saved settings.
The selected button will light up and the screen will show the
saved settings. At this point, you can activate the outputs using
button (14).
3.3.3. Safeguards
1. OCP (over current protection) - the safeguard is activated and
deactivated with the "OCP" button (12).
When the protection is activated, the set current value is
converted to the overcurrent protection value.
When the threshold value is exceeded the protection cuts off
power to the outputs and the device emits a sound signal.
To reset the protection the user has to switch it off using the