Preparation For Operation; Working With The Unit - STAMOS S-LS-96 Manual De Instrucciones

26. Power socket with fuse
27. Feet
28. Power cord
29. Connection wires
3.2.

Preparation for operation

POSITIONING OF THE UNIT
The ambient temperature must not exceed 40°C and ambient humidity should not
exceed 85%. Place the unit in a way that ensures good air circulation. Maintain a
minimum clearance of 10 cm from any wall of the unit. Keep the unit away from
any hot surfaces. Always operate the unit on a level, stable, clean, fireproof and
dry surface and out of the reach of children and persons of impaired mental,
sensory and intellectual functions. Place the unit in such a way that the mains plug
can be reached at any time. Ensure that the power supply to the unit corresponds
to that specified on the identification plate!
3.3.

Working with the unit

To obtain the most stable settings within the tolerance of the PSU device, turn it
on 30 minutes before starting work.
3.3.1. Operation
1. Connect the power cord connector (28) to the socket (26) on the
back of the unit and the plug to a power source.
2. Switch on the device by pressing the ON/OFF button (19).
3. Familiarize yourself with the parameters of the receiving device.
Connect the external load to the terminals (20-22).
4. Set the output parameters according to the instructions in sec.
3.3.2.
5. Press the OFF/ON button (14) to activate the outputs. The button
is illuminated when the outputs are active. Depending on the
connected load, LED (1) or (2) will light up. Device b
6. Press the OFF/ON button (14) again to turn off the power to the
outputs.
The button's backlight will turn off. When the outputs are off,
"OFF" is shown on the power value display (6).
7. If the protection is triggered, the outputs will automatically be
turned off.
8. When you have finished using the unit, turn it off with the ON/OFF
button (19), remove the external load, and unplug the unit from
the power source.